Marine biofilm bacterial community response and carbon steel loss following Deepwater Horizon spill contaminant exposure.

Steel marine structures provide foci of biodiversity when they develop into artificial reefs. Development begins with deposition of a biofilm. The effects of contaminants from oil spills on biofilm microbiomes, microbially-induced corrosion (MIC) and metal loss may impact preservation of marine metal structures. A microcosm experiment exposed biofilms on carbon steel disks (CSDs) to crude oil, dispersant, and dispersed oil to address their impacts on bacterial composition and metal loss and pitting. Biofilm diversity increased over time in all exposures. Community composition in dispersant and dispersed oil treatments deviated from the controls for the duration of a 12-week experiment. As biofilms matured, Pseudomonadaceae increased while Rhodobacteraceae decreased in abundance in dispersed oil treatments compared to the controls and dispersant treatments. Greatest mass loss and deepest pitting on CSDs were observed in dispersed oil treatments, suggesting impacts manifest as a consequence of increased MIC potential on carbon steel.

Automated scanning probe lithography with n-alkanethiol self-assembled monolayers on Au(111): application for teaching undergraduate laboratories.

Controllers for scanning probe instruments can be programmed for automated lithography to generate desired surface arrangements of nanopatterns of organic thin films, such as n-alkanethiol self-assembled monolayers (SAMs). In this report, atomic force microscopy (AFM) methods of lithography known as nanoshaving and nanografting are used to write nanopatterns within organic thin films. Commercial instruments provide software to control the length, direction, speed, and applied force of the scanning motion of the tip. For nanoshaving, higher forces are applied to an AFM tip to selectively remove regions of the matrix monolayer, exposing bare areas of the gold substrate. Nanografting is accomplished by force-induced displacement of molecules of a matrix SAM, followed immediately by the surface self-assembly of n-alkanethiol molecules from solution. Advancements in AFM automation enable rapid protocols for nanolithography, which can be accomplished within the tight time restraints of undergraduate laboratories. Example experiments with scanning probe lithography will be described in this report that were accomplished by undergraduate students during laboratory course activities and research internships in the chemistry department of Louisiana State University. Students were introduced to principles of surface analysis and gained "hands-on" experience with nanoscale chemistry.

Automated scanning probe lithography with n-alkanethiol self assembled monolayers on Au(111): Application for teaching undergraduate laboratories.

Controllers for scanning probe instruments can be programmed for automated lithography to generate desired surface arrangements of nanopatterns of organic thin films, such as n-alkanethiol self-assembled monolayers (SAMs). In this report, atomic force microscopy (AFM) methods of lithography known as nanoshaving and nanografting are used to write nanopatterns within organic thin films. Commercial instruments provide software to control the length, direction, speed, and applied force of the scanning motion of the tip. For nanoshaving, higher forces are applied to an AFM tip to selectively remove regions of the matrix monolayer, exposing bare areas of the gold substrate. Nanografting is accomplished by force-induced displacement of molecules of a matrix SAM, followed immediately by the surface self-assembly of n-alkanethiol molecules from solution. Advancements in AFM automation enable rapid protocols for nanolithography, which can be accomplished within the tight time restraints of undergraduate laboratories. Example experiments with scanning probe lithography (SPL) will be described in this report that were accomplished by undergraduate students during laboratory course activities and research internships in the chemistry department of Louisiana State University. Students were introduced to principles of surface analysis and gained "hands-on" experience with nanoscale chemistry.